Instruction

INSTRUCTIONS FOR ASSEMBLING AND USE OF PALAMITOfacile^Ò

(Picture 1) Fix the axle’s support by means of the four inclusive screws of stainless steel on the ship’s side or on any other surface parallel and at the level of the sea’s surface and however near the ship’s border.

Put the axle from its empty side in the support and block it by means of the screw and the throttle nut (Picture 1).

Put the roll on the axle by the side where the downwards gear-wheel is (Picture 2), so that this latter lays on the white bed by removing the non – return cog if it is necessary (Picture 3).


Fig.1	Fig. 2	Fig. 3

Put the white little disk of nylon on the top of the axle with the broad hole downwards, put in then the handwheel of the clutch and screw the handwheel inside the axle without tightening it (Picture 4).

Put the brass screw in the broad part of the handle and tighten the screw on the yellow little bracket that stretches out from the roll (Picture 5).

Fig. 4

Fig. 5